Pageloader

ARC CS2

0.00

Wear Resistant
  • Low viscosity and long pot life allows for application by brush, roller, or spray
  • Surface-tolerant chemistry allows for application to damp surfaces
  • Accepts aggregate broadcast for improved slip resistance

tuotetunnus (SKU) AWCCS2 Osasto:

Kuvaus

General Purpose Thin-Film Epoxy Coating

100% solids, mineral reinforced, wear resistant, low viscosity epoxy.

ARC CS2 thin film industrial coating is designed to:

  • Protect new and old concrete subject to mild chemical and/or physical damage
  • Replace tiles, outlast paints and other concrete coatings
  • Apply by roller, brush, squeegee, or airless/heated plural component spray

Hyödyt

  • Durable high performance coating
    • Dramatically outlasts conventional paints and coatings
  • 100% solids; no VOC’s; no free isocyanates
    • Enhances safe use
    • No shrinkage on cure
  • Can be applied to dry or damp concrete
    • Saves time by allowing application under a variety of conditions
  • Surface Modified Mineral Reinforcements
    • Excellent resistance to permeation
  • Achieves strong adhesion to concrete
    • Resists delamination and provides long-term protection
  • Adhesion exceeds cohesive strength of concrete

Sovellus

Concrete tanks
Sumps, drains and pits
Pump and equipment bases
Secondary containment
Process floor areas
Water intakes and dams
Wastewater treatment
Conveyor screws
Ceramic tile deflector hoods

Ominsisuudet

Composition Matrix A modified epoxy resin reacted with polyamidoamine curing agent
Composition Reinforcement (Proprietary) Blend of surface modified mineral reinforcements providing resistance to permeation and chemical attack
Cured Density 1.3 gm/cc 81 lb/ cu.ft.
Tensile Adhesion (ASTM D 4541) >35.1 kg/cm2 (>3.4 MPa) > >500 psi Concrete Failure
Compressive Strength (ASTM D 695) 680 kg/cm2 9,650 psi
Tensile Strength (ASTM D 638) 240 kg/cm2 3,380 psi
Tensile Elongation (ASTM D 638) 4.7%
Flexural Strength (ASTM D 790) 410 kg/cm2 5,800 psi
Flexural Modulus (ASTM D 790) 2.5 x 104 kg/cm2 3.5 x 105 psi
Thermal Compatibility to Concrete5 cycles/dry/< -10°C to 50°C (<14°F to 122°F) (ASTM D 884 Modified) Pass
Hardness Shore D (ASTM D 2240) 87
Vertical Sag Resistance at 21°C (70°F) and 150µm (6 mils) No Sag
Maximum Temperature (Dependent on Service) Wet Service
Dry Service
52°C
93°C
125°F
200°F

PDF-tiedostot

Tuotetiedot

Pakkaus

Nominal, based on a 500 µm (20 mil) thickness

  • 16 liter kit covers 32 m2 (344 ft2)
    Note: Components are pre-measured and pre-weighed.
    Each kit includes mixing and application instructions and tools.

Available Colors: Light Gray